The general purpose ultrasonic level sensor provides continuous level detection up to 26.2' with 3 programmable relays for level switch or level control functions, and is configured via the integral push button display module. Each relay can be configured on a single set point (high level alarm or low level alarm) or latched on two set points for automatic fill or empty in simplex (one pump or valve), duplex (two pumps) or triplex (three pumps) level control modes with selectable time delay and fail-safe logic. The embedded level controller can lower cost by replacing external control hardware. This non-contact liquid level sensor is ideally suited for corrosive, sticky or dirty liquids, and is broadly selected for pump lift station, sump and day tank level applications. PVDF transducer and NEMA 4X polycarbonate enclosure for corrosive liquids. Range: 4" to 9.8'. Repeatability: 0.25". Dead band: 4". Beam width: 2". Configuration: push button. Memory: non-volatile. Display type: LCD, 6-digit. Display units: Inch, cm, percent, feet or meter. LCD indication: level and relay status. Supply voltage: 95-250 VAC. Power: 20 watts at 120 VAC. Contact type: (3) SPDT relays. Contact rating: 60 VA, 1A maximum. Contact fail-safe: open, close or hold last. Process temprature: -4 to 140 degreeF. Temprature compensation: automatic. Ambient tempratre: -40 to 140 degreeF. Pressure: MWP equal to 30 PSI. Enclosure rating: NEMA 4X (IP65). Enclosure material: polycarbonate. Enclosure hardware: brass and stainless. Enclosure vent: water tight membrane. Transducer material: PVDF. Conduit entrance: dual, 1/2" NPT. Process mount: 1" NPT. Mount gasket: Viton. Classification: general purpose. Compliance: CE, RoHS.